• minticecream@lemmy.world
    link
    fedilink
    arrow-up
    70
    arrow-down
    1
    ·
    2 months ago

    Turns out early audio consoles with stereo didn’t have a pan knob. They had a pan switch. So choices were limited to left, right, or center (mono).

    Wasn’t til later that the pan pot was invented allowing incremental panning and true stereo mixing.

    • Hammocks4All@lemmy.mlOP
      link
      fedilink
      arrow-up
      8
      arrow-down
      4
      ·
      2 months ago

      That’s wild. But theoretically they could make two separate mono tracks, right? For example, a left mono track with 75% of what would have been an isolated left channel + 25% of the right channel and, similarly, a right mono track with 25% of what would have been an isolated left + 75% of the right. Then, sure, pan switch it fully to left and right.

      • Riley@lemmy.ml
        link
        fedilink
        arrow-up
        4
        ·
        2 months ago

        You have to understand that mixing consoles from that era were supremely limited in channels (think four, eight, later sixteen), to the point where they would often have to mix one section (say, the drums) and then record that mix to tape so it would take up a single channel and then do the guitar, bass, and vocals on another channel. The idea of having two of the same thing going through two channels was an exorbitant luxury they couldn’t afford!

    • ChickenLadyLovesLife@lemmy.world
      link
      fedilink
      English
      arrow-up
      4
      ·
      2 months ago

      I mean this is true but not about the '70s as the original post states. Even by the '60s they had sophisticated stereo audio mixers - they just cost hundreds of thousands of dollars instead of running on people’s phones like today.